The effects of horizontal load speed and lifting frequency on lifting technique and biomechanics

Date
2010-01-01
Authors
Dai, Boyi
Mirka, Gary
Jin, Sangeun
Ning, Xiaopeng
Mirka, Gary
Journal Title
Journal ISSN
Volume Title
Publisher
Source URI
Altmetrics
Authors
Mirka, Gary
Person
Research Projects
Organizational Units
Journal Issue
Series
Abstract

Lifting loads that have a horizontal velocity (e.g. lifting from a conveyor) is often seen in industry and it was hypothesised that the inertial characteristics of these loads may influence lifting technique and low back stress. Seventeen male participants were asked to perform lifting tasks under conditions of four horizontal load speeds (0 m/s, 0.7 m/s, 1.3 m/s and 2.4 m/s) and two lifting frequencies (10 and 20 lifts/min) while trunk motions and trunk muscle activation levels were monitored. Results revealed that increasing horizontal load speed from 0 m/s to 2.4 m/s resulted in an increase in peak sagittal angle (73° vs. 81°) but lower levels of peak sagittal plane angular acceleration (480°/s2 vs. 4°/s2) and peak transverse plane angular acceleration (200°/s per s vs. 140°/s per s) and a consistent increase in trunk muscle co-activation. Participants used the inertia of the load to reduce the peak dynamics of the lifting motion at a cost of increased trunk flexion and higher muscle activity.

Description
<p>This is a manuscript of an article published as Dai 1, Boyi, Sangeun Jin 1, Xiaopeng Ning, and Gary A. Mirka. "The effects of horizontal load speed and lifting frequency on lifting technique and biomechanics." <em>Ergonomics</em> 53, no. 8 (2010): 1024-1032. <a href="http://dx.doi.org/10.1080/00140139.2010.493957" target="_blank">doi:10.1080/00140139.2010.493957</a>. Posted with permission.</p>
Keywords
conveyor, electromyography, frequency, lifting, load speed, trunk kinematics
Citation
Collections